Installer North West/North Wales
Thu, 21 Jun 2007 13:17:58 -0000
Can someone recomend an installer in the North West of England or
North Wales ?
...
|
Installer North West/North Wales
Thu, 21 Jun 2007 13:17:58 -0000
Can someone recomend an installer in the North West of England or
North Wales ?
...
|
Installer North West/North Wales
Thu, 21 Jun 2007 13:17:58 -0000
Can someone recomend an installer in the North West of England or
North Wales ?
...
|
Lambda gas control and carburetor engines
Mon, 4 Jun 2007 16:26:53 +0200
I have open loop LPG system on my '87 BMW 316 (carburetor). I was
advised to go closed loop. I found few lambda gas control kits online,
and I thought I could ask here if this is a good idea.
Am I going to benefit from going closed loop (and is it possible to do
so on the engine with carburetor)? Lower fuel cons ...
|
OT lpg tank
Thu, 31 May 2007 14:53:52 +0100
Does anyone know what happens to old lpg static refueling tanks that
have become below standard as a pressure vessel?
I'm looking for a substantial steel cylindrical tank of about 4500
litre capacity but cheap.
AJH ...
|
Lambda gas control and carburetor engines
Mon, 4 Jun 2007 16:26:53 +0200
I have open loop LPG system on my '87 BMW 316 (carburetor). I was
advised to go closed loop. I found few lambda gas control kits online,
and I thought I could ask here if this is a good idea.
Am I going to benefit from going closed loop (and is it possible to do
so on the engine with carburetor)? Lower fuel cons ...
|
Ford Focus bi-fuel mapping
21 May 2007 01:36:43 -0700
I've got an 04 Focus 1.8 Bi-fuel (factory lpg - not a conversion)
which dies when cold starting and won't switch to lpg until warmed up
after about 2 miles. I'm told by those in the know that it is running
too lean and needs remapping.
My local garage's lpg expert says he can't do the job and only Ford
can do ...
|
How to calculate mixer size?
Sun, 20 May 2007 20:57:22 +0200
I have '87 BMW 316 with problematic Pierburg 1B2 carb (one barrel),
that I am replacing with Weber 32 ADF. So to be able to fit existing
filter housing I have to fabricate custom housing carrier / lpg mixer.
My carburetor is not here yet - it has two 32 mm progressive barrels,
so how do you decide on mixer size? I ...
|
How To Promote Your Business To Thousands While Your Drive
24 May 2007 09:00:54 -0700
Have you heard about ID Plates?
It is the ultimate and best way to promote your company, business,
website, etc while you drive your car.
Please take a look at this website. You will be surprised!!!
http://idplates.blogspot.com
...
|
LPG problem
Fri, 25 May 2007 17:19:24 GMT
03 Daihatsu Hijet, 1.3 16 valve van.
LPG system PRINS AFS3
When I'm driving along after about ten miles, the gas system suddenly shuts
down. All the green LEDs on the gauge, go off and the red warning triangle
LED flashes even though there is plenty of gas in the tank. I switch over to
petrol and a short w ...
|
